Adhesive P5000
Adhesive P5000
Product Briefing
This product is a powdery adhesive made from high-grade Portland cement, specially selected high hardness graded sand, and professionally formulated additives such as anti sagging and water retention factors. Special additives can ensure sufficient hydration of cement components, greatly improving the bonding strength. It is a professional and high-quality adhesive with high cost-effectiveness. Suitable for indoor and outdoor pasting of tiles, stones, mosaics, and other materials. At the same time, there are matching products for various surface materials such as thin sheets, artificial stones, and microcrystalline stones.
Product Features
High bonding strength
Good construction performance
anti-sliding
Green and environmentally friendly
Product color/specification
Product color: Grey/White
Product specification: 40kg/bag
Scope of application
Suitable for tiling base layers such as concrete, masonry walls, cement mortar leveling layers, cement lining boards, gypsum boards, etc.
Execution standards
JC/T 547-2017 C1T type
Construction method
Base treatment
The base layer should be solid, clean, free from shaking, oil stains, wax stains, concrete curing agents, and other loose materials. Before construction, it is necessary to wet the base layer to a dry outside and wet inside state in areas with high water absorption or in high-temperature and dry environments. The flatness of the grassroots should be ensured to be less than 3mm/2m per meter. If the requirements cannot be met, leveling should be carried out first or a scraper with a larger tooth depth should be selected during construction.
Preparation of adhesive slurry
Add an appropriate amount of water to the mixing bucket and slowly add the powder while stirring. The mixing ratio is 40kg of powder and 9-10L of water (subject to convenient construction). Stir evenly with an electric mixer until there are no lumps, let it sit for 5-10 minutes, and mix thoroughly again before use. It is best to complete the construction within 2 hours.
Ceramic tile pasting
Use a toothed scraper to apply tile adhesive to the base layer, evenly distribute it, and comb it into tooth shaped strips. Apply about 1 square meter each time, and then knead and press the tiles on top during the drying time. The depth of the scraper teeth should consider the flatness of the working surface and the unevenness of the back of the ceramic tiles.
Precautions
The optimal construction temperature should be between 5-35 ℃.
This product does not have waterproof effect. Please use waterproof products if needed.
The base surface must be flat and sturdy, and it is recommended to use the "thin layer construction method".
Ensure the fullness during construction and maintain complete contact between the contact surfaces.
Before solidification, protection must be carried out to avoid outdoor construction in rainy weather, so as not to affect the quality.
This product contains cement ingredients, and attention should be paid to protecting the eyes. In case of contact, it can be washed with plenty of water.
Reference amount
(Approximate value, depending on the flatness of the base surface)
| Specification of toothed scraper | usage |
| 6mm*6mm | 3kg/㎡ |
| 10mm*10mm | 5kg/㎡ |
| 12mm*12mm | 8kg/㎡ |
Transportation and storage
Avoid rain and sun exposure during transportation. Store in a cool and dry warehouse to prevent moisture and strictly prohibit contact with water.
Storage period: 12 months.
