Joint filler S500
Joint filler S500
Product Briefing
This product is a sand based ceramic tile and stone joint filler made from high-quality colorants, selected graded sand, high-grade Portland cement, and specially formulated polymers and other additives. This product has small shrinkage, good crack resistance, and high flexibility, suitable for wide seams of 3 millimeters or more. It has good hydrophobicity, effectively inhibits alkali bleeding, and has a uniform and beautiful color. Suitable for filling joints of various types of tiles, stones, etc. indoors and outdoors. There are matching products for various surface materials such as thin sheets, artificial stones, vitrified tiles, and microcrystalline stones.
Product Features
High bonding strength
Inhibit ubiquitination
Weather resistant and mildew resistant
Green and environmentally friendly
Product specifications
Product specification: 40kg/bag
Scope of application
Suitable for filling wide joints of 3mm or more in various ceramic tiles and stone materials, both indoors and outdoors, as well as on walls and floors.
Execution standards
JC/T1004-2017 CG1 type
Construction method
Base treatment
Joint filling should be carried out after the adhesive has completely dried and solidified. Clean the tile joints to make them clean, and fill at least 2/3 of the thickness of the tile joints. It is best to clean them before the adhesive has completely dried and solidified. In high temperature and strong wind weather, it is necessary to wet the joints of porous bricks with clean water.
Product preparation
Add an appropriate amount of water to the mixing bucket and slowly add the powder while stirring. The mixing ratio is about 8 liters of water per bag of 40 kilograms of sealant. (Based on the convenience of construction). Mix with an electric mixer until there are no lumps, let it sit for 3 minutes, and mix thoroughly again before use. It is best to complete the construction within 2 hours.
Joint filling construction
Use a rubber scraper to fill the joints with the prepared grout, remove excess grout from the surface, and when the grout is not yet dry, use a scraper diagonally to remove excess grout.
clean
Usually, it takes 10-20 minutes for the grout to cure, and then use a wet sponge to remove excess slurry diagonally.
Precautions
The optimal construction temperature should be between 5-35 ℃.
This product does not have waterproof effect. Please use waterproof products if needed.
This product is not suitable for narrow seams below 3 millimeters.
Highly absorbent ceramic tiles and stones should be tested for the degree of penetration of the grout before filling the joints. For those that are difficult to clean, the tile surface should be sealed with sealant before filling the joints.
Acid based products cannot be used to clean joint sealants.
Before solidification, protection must be carried out to avoid outdoor construction in rainy weather, so as not to affect the quality and cause alkali bleeding.
This product contains cement ingredients, and attention should be paid to protecting the eyes. In case of contact, it can be washed with plenty of water.
Reference amount
Transportation and storage
Avoid rain and sun exposure during transportation. Store in a cool and dry warehouse to prevent moisture and strictly prohibit contact with water.
Storage period: 12 months.
